Concrete Testing Services in Malaysia

Foundtest delivers accurate, standard-compliant concrete testing across Malaysia for developers, contractors, consulting engineers, and building owners. From routine 28-day cube tests on active construction sites to non-destructive strength assessment of existing structures, our team applies the correct test method to answer the question at hand — whether that is quality control on fresh concrete, in-situ strength verification, or forensic assessment of ageing structures.

Every test we perform conforms to Malaysian Standards (MS EN), British Standards (BS EN), and ASTM references. Our reports are prepared to a standard accepted by JKR, CIDB, consulting engineers, and local authorities.

Concrete Testing Services We Offer

Cube Compressive Strength Test

Primary quality control test for fresh concrete. Cubes are cast on site and crushed at 7 and 28 days to verify design strength.

Rebound Hammer Test

Rapid, non-destructive surface hardness assessment. Ideal for uniformity checks across large structures.

Windsor Probe Test

Semi-destructive penetration test correlating probe embedment depth to in-situ compressive strength.

Concrete Core Test

Extraction and laboratory testing of cores — the most reliable method for determining in-situ compressive strength.

When Do You Need Concrete Testing?

  • New construction quality control

    Cube tests and batch verification during active construction.

  • Investigation of low or non-conforming cube results

    Rebound hammer, UPV, and core tests to determine actual in-situ strength.

  • Assessment of existing buildings

    Before renovation, change of use, or structural modification.

  • Forensic and defect investigation

    Cracking, spalling, and delamination assessment.

  • Load rating and capacity checks

    For bridges, industrial floors, and structures reaching design life.

  • Insurance and dispute resolution

    Independent third-party strength assessment.

Why Foundtest for Concrete Testing?

  • Operating since 2004 with a dedicated concrete testing division

  • Reports accepted by JKR, CIDB, consulting engineers, and Malaysian local authorities

  • Combined field and laboratory capability — we execute the full test cycle in-house

  • Calibrated equipment with traceable calibration certificates

  • Coverage nationwide from our Puchong Selangor base

Frequently Asked Questions

It depends on what you are trying to find out. For quality control on newly placed concrete, cube tests are standard. For assessing existing structures without damage, use rebound hammer and UPV. Where the highest accuracy is needed on hardened concrete, extract cores. We can advise on the right combination for your project.

Yes. Our test methods conform to Malaysian Standards (MS EN), British Standards (BS EN), and ASTM references — all accepted by JKR, CIDB, and Malaysian consulting engineers.

Rebound hammer and UPV field reports are typically issued within 3–5 working days. Cube crushing is scheduled to your specified age (usually 7 and 28 days). Core tests take 5–7 working days from extraction to reporting.

Yes. We serve all of Peninsular Malaysia from our Puchong office, and travel to East Malaysia projects for larger scopes.

Yes — combining rebound hammer, UPV, and core sampling on a single mobilisation is often the most cost-effective approach and gives the most reliable assessment.

Get a Quote for Your Concrete Testing Project

Speak to our engineers about the right test method for your project. Call +603-8051 5333, WhatsApp us, or use the contact form for a same-day response.

Contact Us Now
© Copyright - Foundtest (M) Sdn Bhd (647755-P)